Denor Fluid Equipment (wuhan) Co., Ltd.
Denor Fluid Equipment (wuhan) Co., Ltd.
Add to Cart
Flood control vacuum assisted self-priming pump strong self-priming pump
| Material | cast iron | Drive mode | electric |
|---|---|---|---|
| Pump shaft position | Horizontal | Impeller structure | Semi-open impeller |
| performance | Non-blocking | Impeller suction method | Single suction |
| Lift | 1-130m | Speed | 2900-960r/m |
| power | 5500-315000w | flow | 100-6000m³/h |
Flood control vacuum assisted self-priming pump has a maximum flow rate of 6000m3/h, so the main advantage of this pump is its wide flow range. The main feature of the vacuum assisted self-priming pump with open impeller self-priming pump is that it has a particularly good anti-blocking effect and will not cause any blockage, and its self-priming capacity can reach 9 meters.
Flood Control Vacuum Assisted Self-Priming Pump
Product Overview;
The vacuum-assisted self-priming pump is mainly based on the strong self-priming pump and the open impeller self-priming pump, which adds a vacuum-assisted system. The self-priming pump with the vacuum-assisted system has improved its self-priming performance to a higher level. If the vacuum-assisted self-priming pump adopts a strong self-priming pump product, the self-priming height can reach 9 meters, and the flow rate of this pump can be within 6000m3/h at most. Therefore, the main advantage of this pump is its wide flow range. The main feature of the vacuum-assisted self-priming pump using an open impeller self-priming pump is that the anti-blocking effect is particularly obvious, and there will be no blockage, and the self-priming capacity can reach 9 meters. If the transported liquid contains a lot of debris, it is recommended to use an open impeller vacuum-assisted self-priming pump product. However, the maximum flow rate of this open impeller vacuum-assisted self-priming pump is only 800m3/h. If a larger flow rate is required, it needs to be customized and the production cycle is about 1 month.
Conditions for use of self-priming pumps with vacuum assist system
1. The ambient temperature of the vacuum-assisted self-priming pump should be less than 50°C, and the temperature of the liquid is usually less than 100°C. Special requirements can be customized.
2. The cast iron vacuum-assisted self-priming pump is suitable for conveying liquids with a pH value of 6 to 9, while the stainless steel vacuum-assisted self-priming pump is suitable for conveying liquids with a pH value of 2 to 13.
3. The weight of the liquid used by the vacuum-assisted self-priming pump does not exceed 1240kg/m3. When conveying sewage, the lift in the parameter table is 10% lower than that of the clean water type. Therefore, attention should be paid when selecting the type. If the sewage is conveyed, for example, a lift of 10 meters is required, then it is recommended to use a pump with a lift of 15 meters.
4. The self-priming height of the vacuum-assisted self-priming pump cannot exceed the specified value range.
5. The diameter of suspended particles in the vacuum-assisted self-priming pump is about 20% of the pump diameter, and the fiber length is 5 times the diameter of the vacuum-assisted self-priming pump.
